loading
reading
writing
saving
searching
Toyota 22RE Fully Rebuilt Motor - Turnkey - Options 84-95 Low Miles - $3,000 (Shingle Springs)
QR Code Link to This Post
Rebuild specs are; .040" over Pistons (.016" Clearance), .010" Shaved Deck, Polished Crank, King Bearings - Shaved Rebuilt Head with new Toyota valves and RV Cam.
*I popped the valve cover off and everything looks as good as the day it was built.
This is a proven motor with less than 20k miles, primarily used for Highway and around town. Motor was Rebuilt for upping performance without triggering issues with CARB, so it runs really strong and passes smog without issue.
Oil and filter changes - Valvoline full synthetic every 3k-4k miles (depending on the condition of the oil).
I freshened up the Long Block to improve the aesthetics, and stripped down certain components to accommodate a more universal use.
New Replacement of front Crankshaft Seal (Oil Pump), rear Main Seal, and Valve Cover Seal. [Seals are in great shape and don't leak, but if you want them replaced I'll do it at no additional cost - Or you can take them with you. OEM, valued at $100]
It comes with a written One Year/12,000 Mile Internal Engine Warranty. But I will discount the price if you don't want the Warranty.
Turnkey Option:
The Turnkey Motor set-up I can provide comes with the fully dressed Long Block (Timing Cover with Water Pump and Oil Pump, Oil Pan, Valve Cover, new Spark Plugs, and new Oil.) - and these 1990/91 components; Exhaust Manifold (with new Gasket), Harmonic Balancer, Knock Sensor, Fuel Filter Bracket, Thermal Coolant Tubes (3), Coolant Intake Tube, EGR, AS assembly, AS Pipe, Blowby Vent Hoses, Oil Pressure Switch, Distributor, distributor Wires, water pump Pulley, Engine mounting Brackets, Upper alternator Bracket, Lower alternator Bracket, Pilot shaft Bearing, and proper reconditioned OEM Hardware.
[Turnkey Motor sold for Installation only, unless ancillary components would be exchanged. *Some components may not be available down the road.]
With Components $3500
Other Options:
I also have the Vacuum Network, and the 3 VSV vacuum Valves mounted on the VSV Plate available. Generally those are application specific (Later models - Oval connectors), so we can see what is needed.
ARP Head Studs for the cost of the Studs - the installation cost would be included.
I may install the Turnkey Engine for a low Flat Rate cost, if you require a complete Turnkey solution. Includes Deinstallation, Installation, and System evaluation.
I prefer inquiries to be in writing, that we both have a record of all the details. But if you are Text shy you can leave voice messages, and I'll compose the written Question and Answer responses. TY